Napoleon-fireplaces BGNV42P Bedienungsanleitung PDF herunterladen (Seite 5)

W415-0377 / 03.04.03

This is a vented appliance and must be connected to a

chimney in accordance with the current installation codes.

In absence of local codes, install to the current National

Fuel Gas Code, ANSI Z223.1, or the current CAN/CGA B149,

Installation Codes. This model can be common-vented.

A minimum six inch diameter (6"ø) B-vent or class A vent is

required. A minimum 10' vent height is required. Secure

the B-vent to the exhaust collar on the stove top with 3

screws. In cold climates, the use of a B-vent and an insu-

lated chase is recommended.

This thermally activated switch, located in front of the draft

hood, senses an increase in temperature and acts as a

safety shut-off (See 'A' below). It shuts down the gas to the

main burner in the event of a severe downdraft of air or a

blocked or disconnected chimney flue. If the flue is blocked

or has no "draw", the safety switch will automatically shut

off the supply of gas to the main burner within 10 minutes.

This switch must be manually reset by depress-

ing the plunger. Refer to Figure 2.

Tampering with the safety switch can result in

carbon monoxide poisoning and possible death.

This thermally activated switch, located in front of the draft

hood, senses an increase in temperature and acts as a

safety shut-off (See 'A' below). It shuts down the gas to the

main burner in the unlikely event of the unit overheating.

The HI Limit switch will automatically reset after the unit

has cooled down, resuming gas flow to the main burner.

A test for correct venting action must be made before

the installed unit can be left with the customer.

Follow the procedure below:

1. Close all doors and windows in the room / start ex-

haust fans in the home / turn the fireplace blower off (if so

equipped).

2. Set controls to "high" and light the unit.

3. Wait 5 minutes. Light a match and hold to the front of

the draft hood. FIGURES 4 & 5.

FIGURE 4

FIGURE 3

Venting action is satisfactory, if smoke and flames are

drawn into the draft hood.

Venting action is unsatisfactory, if the smoke spills back, and

the flame splays outward. If venting action is unsatisfactory,

turn off the unit, wait 10 minutes and try again. If the smoke is

still not drawn into the draft hood, turn the unit off and check for

vent blockage or restriction. If necessary, consult with a quali-

fied inspector.

The Vent Safety or Hi Limit switches must not be

adjusted or disabled.

In the event that either switch or any associated

parts are exchanged, only original manufacturer's

parts may be used.

FIGURE 2

PLUNGER

VALVE

THERMOSTAT OR

WALL SWITCH

VENT SAFETY

SWITCH

HIGH LIMIT

SWITCH

FIGURE 5

HI LIMIT

SWITCH

VENTING

VENT SAFETY SWITCH

HIGH LIMIT SWITCH

VENTING ACTION CHECK

1 2 3 4 5 6 7 8 9 10 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Napoleon-fireplaces BGNV42P Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ofen Napoleon-fireplaces BGNV42P